MotoCrane RADICAL Error 102: Lift Encoder Data Invalid
The lift encoder is not sending valid data. Limits are blocked while this is active, and the position gauge may stop working.
Warning: yellow icon, one beep. Keep working with care.
What to do
- Run the Lift Encoder Calibration and power cycle.
- Contact MotoCrane Support if it persists.
First, always: check every cable and the COM and Power LEDs on each module. Axis: lift. Applies to MotoCrane RADICAL.
Code 102 on ULTRA is different: ULTRA Error 102: Lift Encoder Data Invalid.
Print the RADICAL code card (PDF)