MotoCrane RADICAL Error 233: Lift Control Mode Disabled From Error
Each control mode needs certain hardware working. STANDARD mode on the lift axis needs steady data from the lift encoder. If that data drops out, the system leaves STANDARD mode and shows this code. It also appears if too much lift travel trips the mechanical limit switch.
Error: red icon, repeated beeps until acknowledged. Fix before you continue.
What to do
- Check STATUS and LOG to find the cause.
- Power cycle and try to re-enable the mode.
First, always: check every cable and the COM and Power LEDs on each module. Axis: lift. Applies to MotoCrane RADICAL.
Print the RADICAL code card (PDF)